PDA

View Full Version : how do u change the fog light bulbs on FN2???



Ninjadust77
16-06-2008, 01:04 PM
i have some H11s i want to put in the fog lights but i cant find out how to access the rear of the fog lights so that i can change the bulbs :( i have checked underneath the car and its all flat, there is like a front diffuser underneath and i really dont wanna have to take the whole thing off just to change the bulbs

if anyone has replaced the fog light bulbs on the FN2 pls advise how u done it...

thanks
NinjaDust77

LD_Mart
16-06-2008, 01:13 PM
Driver side - under the front skirt you will see two holes. look up them and i think it is the left one. you will see a bolt..
you need a 12mm socket with exstension to undo the bolt...
then the fog light just falls out the front...

Left side - You need to undo the wheel guard...
so first undo the little black clip on the bottom of the front skirt and wheel guard..
pull back the arch protecter thing...
then you will be able to pull the wheel guard away...
you will see the fog light stick your hand in there and reach for the bulb...

Ninjadust77
17-06-2008, 12:25 PM
Driver side - under the front skirt you will see two holes. look up them and i think it is the left one. you will see a bolt..
you need a 12mm socket with exstension to undo the bolt...
then the fog light just falls out the front...

Left side - You need to undo the wheel guard...
so first undo the little black clip on the bottom of the front skirt and wheel guard..
pull back the arch protecter thing...
then you will be able to pull the wheel guard away...
you will see the fog light stick your hand in there and reach for the bulb...

is this the only way to replace the bulb for the driver side or would i be able to do the same thing as u described from the passenger side?

thanks for the info :thumbsup:

LD_Mart
17-06-2008, 12:35 PM
No you cant do it on the driver side i tried...
theres things in the way so you cant even see the fog light....

but once i did the driver side its so much easier then the passenger side...
just undo one bolt and your done...