B18C half cut

[furiou5]

Hi roughly how much does a B18C (vtir) half cut go for these days,
what is needed from the falf cut to swap it into a 99 cxi.
thanks

[geo41e]

3-4k ?

[DCLXVI]

probably more.

[flipmods]

$3700 at just Jap when they get one in but you will still need mounts.

[SiR JDM]

Depending on condition of 1/2 cut..
ie - kms, condition of parts, if all parts are there etc..
if its jdm or not
where your gettin it from - ie wrecker or just a guy who wants to get rid of his post-accident car..

but id asume anywhere from 3-5k depending... they are alot rarer than the b16s from my experience..

Whats involved?
Move everything from the 1/2 cut to the CXi engine bay =D

nah seriously, u will need to firstly get new engine mounts for the b18, you wont be able to use ur exisiting engine mounts..
Then you will pretty much do wat i said above.. chuck everything into the engine bay...
You will need to change the wiring loom and rewire the engine to the ECU (make sure this is with the 1/2 cut)
You will alos need to change the whole Gearbox, gearlinkage, clutch and pressure plate all from d-series to b-series..

Make sure all these parts are with 1/2 cut cuz if anything is missing it can be very hard and expensive to find at wreckers or aftermarket...

[carbine]

Rear tranny mount and passenger side mount bracket from vti-r

well thats what i thought anyway

use the rest from the cxi/gli and intregra clip

[panda[cRx]]

got my jdm b18c1 for 2100 with gearbox^^
however like sirjdm says there are lots of bits and pieces required and the honda wreckers in vic are pretty shitty =/
although i managed to get everything but my ecu so far^^

[flipmods]

Check ebay as there is currently a front cut for $3500.

[SiR JDM]

Wow panda[CRX] thats pretty damn cheap!
For 2100 u could just chuck a hondata or microtech in there straight away and forget the OEM ecu ! thats cheap! gw mate =)

[pornstar]

now all u need are wiring harness, shift linkages, driveshafts etc not much at all ;)

[panda[cRx]]

sif mate, i got all that....
all i need is for u to donate your turbo setup and internals :)
like i said all i need is ecu, wanted power fc but requires obd1 > obd2 conversion so prolly goin microtech

[pornstar]

u wanna tell them anything else sherlock? perhaps whats unnder my hood? what coiulovers? gawd

[egvtec]

Have a cry.............. he said it was turbo and had internals i think any with half a brain would have figured that out by how much u DON'T go on about ur car