View Full Version : DC2 optional skirts.
xtat1k
02-07-2008, 10:26 PM
Ok, what would be the best way that makes it sit flush + easy way to install the optional skirts. its not oem so you have to slip it over the stock skirts.
Cheers.
VTECMACHINE
03-07-2008, 09:49 AM
The OEM optional skirts... are OEM. They are direct replacements of the smaller skirts.
G-Stick
03-07-2008, 10:00 AM
he said its not the oem ones and they are replicas that sit over the stock ones
VTECMACHINE
03-07-2008, 10:10 AM
he said its not the oem ones and they are replicas that sit over the stock ones
Well my bet, is that they won't fit properly. I bought some of these, but Mugen replicas previously. They didn't fit properly, and were so thin, they cracked as I was slipping them over the stock skirts.
But just be prepared to use alot of double sided sticky tape.
G-Stick
03-07-2008, 11:31 AM
nah they should be fine, just post up the pics xtat1k. ive personally had a replica set and they fit find. a few of the members on here can vouch for them.
xtat1k
03-07-2008, 12:00 PM
I've put the skirts over my stock ones and the fitment isnt too bad.
The thing that im wondering is .. what should i use to mount em down.
Eg. drill holes and put nails, rivets, sikaflex, glue.
G-Stick
03-07-2008, 12:09 PM
pm sent
dupac->
03-07-2008, 12:11 PM
albert use sikaflex for the gaps and screw them in through the rear and then same through the front!!
xtat1k
03-07-2008, 01:28 PM
thanks for the info G-stick !
ok dupac. time to go buy sikaflex!
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.