Interior not flush

[Lukey]

Ok, title doesnt really help but I couldnt think of anything else.

Anyways, on the passenger side, the bit of interior near the bottom of the door isnt sitting flush like the passenger side.


Heres the drivers side.
http://i35.tinypic.com/1q4m5h.jpg

Heres the passenger side.
http://i33.tinypic.com/50fvc9.jpg



Anyone know how to fix it so it sits flush like the drivers side?

[tRipitaka]

should be held down by clips.. maybe one of your clips have broken

[Lukey]

Ive seen a clip there when i pull it up a tad but cant seem to move it or anything. I'm thinking I might have to take out back seats and remove the whole side interior.

[tRipitaka]

should be able to just push down on it until you hear a click

[Lukey]

i can push it down a little bit but doesnt go fully down, but when i do, it makes a click.

[VTECMACHINE]

Twisted Chassis!!! :D

[vinnY]

^ too much tork!

my guess is that your passenger side rear interior trim isn't aligned properly, take it off and see whats going on under there

[Lukey]

Twisted Chassis!!! :D

Whats that meant to mean? It has only been recently its been like this.


^ too much tork!

my guess is that your passenger side rear interior trim isn't aligned properly, take it off and see whats going on under there

I'd have to remove back seats for this, I'll try and tackle it this weekend.

[vinnY]

yep find the source by taking it apart.. don't keep trying to force it as it might break something behind it
remember its just plastic back there
my guess is one of the interior trim clips have come loose and its caught on something and not letting you put it back into place
it'll take about 10 minutes to get the interior trim off.. easy as :)

[Lukey]

Ill start taking it all apart tomorrow.

[cal213]

while its like that, run your amp wiring.... XD

[Lukey]

im too poor for stereo you douche