ej20i
14-08-2008, 11:02 PM
Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
Aim: To Install Civic FD2R Push start in a normal FD
Required: 1.Push start (dmx sells em)
2. 1m 14 gauge wires
3. 2m 16 gauge wires
4. 12 Volts relay
Steps: I'm not going to post the whole step by step procedures since it was kinda stressfull for me to take photos.
but heres the wiring diagram
http://i193.photobucket.com/albums/z257/ej20i/593653DIY20start20button20pic1.jpg
instead of the brown harness, its white and its located at the top row of the fuse box inside the cabin. The white and yellow wire is there.
Other comments:photo was taken from 8thcivic forum
Aim: To Install Civic FD2R Push start in a normal FD
Required: 1.Push start (dmx sells em)
2. 1m 14 gauge wires
3. 2m 16 gauge wires
4. 12 Volts relay
Steps: I'm not going to post the whole step by step procedures since it was kinda stressfull for me to take photos.
but heres the wiring diagram
http://i193.photobucket.com/albums/z257/ej20i/593653DIY20start20button20pic1.jpg
instead of the brown harness, its white and its located at the top row of the fuse box inside the cabin. The white and yellow wire is there.
Other comments:photo was taken from 8thcivic forum