PDA

View Full Version : People been asking where to find the gromit for their Amp power... here it is


BraXta
15-08-2008, 12:07 AM
thought i would take some photos on where this gromit is ... since people always have issues finding it =D

Looking in engine bay
http://i281.photobucket.com/albums/kk220/braxta/Gromit01Small.jpg

Gettin up and under and seeing the actual gromit
http://i281.photobucket.com/albums/kk220/braxta/Gromit02Small.jpg

ill get a photo next of where it appears in the car but its just near the centre console under glovebox =D

Hope this helps the self stereo installers
tony1234
15-08-2008, 07:32 AM
Nice pics.Shows exactly where power/amp cable goes through.I've been too lazy to take pics and post them up.:o
SuiJin
15-08-2008, 07:52 AM
why would u have a distributor in your engine bay. shouldn't you just run one zero gauge to the boot and have a distributor there. saves having so many different mods in the engine and losing room.
tron07
15-08-2008, 09:27 AM
you will need to have a fuse as near to the battery as possible. Not futher then 18 cm away
BraXta
16-08-2008, 12:39 AM
and it worked out cheaper to run 2 smaller cables than one massive one =P
.QD
18-08-2008, 02:02 AM
nice pix man. i forgot i needed to reattach the rubber grommet back to the plastic grommet.. must add in the to do.
crunkman99
18-08-2008, 04:29 PM
do you find a lot of trouble with things shaking and rattleing in the boot from the subs?

if so how did you stop it?

by the way, you have to put the gauge wireing through the left side of the gromit so it fits when it comes out underneath the glove box
Pumped
18-08-2008, 04:33 PM
0 gauge aint much fun to run through there i must say, 2 runs would be a more manageable choice i think
beeza
18-08-2008, 04:44 PM
do you find a lot of trouble with things shaking and rattleing in the boot from the subs?

if so how did you stop it?

by the way, you have to put the gauge wireing through the left side of the gromit so it fits when it comes out underneath the glove box

No,the only issue I had was the number plate but 2 little rubber bits (sticky on one side fixed that.You can turn the gain down on the amp for the sub if it's too much.
Just get it through any way,the bottom really cause it needs to run downwards to the centre console or down the side.