bummy
15-08-2008, 10:41 PM
Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
Aim: A step closer to JDM interior
Required:
*Screwdriver
*New shift boot with red stitching
Steps:
1. Unscrew all the screws marked with green circles (4 screws), need to pry open clip below handbrake to access 2 other hidden screws.
2. Twist off the gear knob and then pull out the whole plastic cover.
http://i516.photobucket.com/albums/u323/breadbaconncheese/1v2.jpg
3. Unscrew 2 screws thats holding your shift boot bracket to the plastic cover
http://i516.photobucket.com/albums/u323/breadbaconncheese/2v2.jpg
4. Take off EK shift boot and put it in your EG bracket. (EK bracket is not the same with EG bracket, so you will need to swap the shift boot)
http://i516.photobucket.com/albums/u323/breadbaconncheese/3v2.jpg
http://i516.photobucket.com/albums/u323/breadbaconncheese/4v2.jpg
5. Screw the EG bracket (now with red stitching) back onto plastic cover.
http://i516.photobucket.com/albums/u323/breadbaconncheese/5v2.jpg
6. Put everything back and don't forget to clip the clip back on
http://i516.photobucket.com/albums/u323/breadbaconncheese/6v2.jpg
7. done.
Other comments: Comments welcome. Corrections welcome. Thanks.
Aim: A step closer to JDM interior
Required:
*Screwdriver
*New shift boot with red stitching
Steps:
1. Unscrew all the screws marked with green circles (4 screws), need to pry open clip below handbrake to access 2 other hidden screws.
2. Twist off the gear knob and then pull out the whole plastic cover.
http://i516.photobucket.com/albums/u323/breadbaconncheese/1v2.jpg
3. Unscrew 2 screws thats holding your shift boot bracket to the plastic cover
http://i516.photobucket.com/albums/u323/breadbaconncheese/2v2.jpg
4. Take off EK shift boot and put it in your EG bracket. (EK bracket is not the same with EG bracket, so you will need to swap the shift boot)
http://i516.photobucket.com/albums/u323/breadbaconncheese/3v2.jpg
http://i516.photobucket.com/albums/u323/breadbaconncheese/4v2.jpg
5. Screw the EG bracket (now with red stitching) back onto plastic cover.
http://i516.photobucket.com/albums/u323/breadbaconncheese/5v2.jpg
6. Put everything back and don't forget to clip the clip back on
http://i516.photobucket.com/albums/u323/breadbaconncheese/6v2.jpg
7. done.
Other comments: Comments welcome. Corrections welcome. Thanks.