EK1.6LCIV
24-08-2008, 08:17 PM
J's Racing Canards
Upon arrival you get two very well crafted pieces of carbon fibre along with the required brackets, washers, nuts and screws. This kit was bought from JDMConcept and arrived in perfect condition, props for brilliant service :thumbsup:
http://i224.photobucket.com/albums/dd127/kwelrap/DSCF1673.jpg
Then you will need to drill in three holes in each canard for your brackets to be held into place with, **caution is advised**, if above all else please go to a body shop for this if you're not feeling confident as fixing cf is not a great task.** So we did some mock ups on the car and aligned the canards and bent the brackets to suit the required angle we were after.
http://i169.photobucket.com/albums/u231/ch3zza_2007/DSCF1697.jpg
We then drilled into the front bar using the mounting brackets as a guide, then with the bar off attached the nuts, screws and washers up to the brackets. All of which lined up perfectly.
Although with some aftermarket products alterations have to be made and on the one side we had to shave some of the canard off on the inside to sit completely flush with the factory front bar.
http://i169.photobucket.com/albums/u231/ch3zza_2007/DSCF1720.jpg
But in the end they mounted very well with only minor adjustments having to be made and fitted up in a little over an hour, they do make these canards for EG, EK and DC2 models as well fitting the same with a brilliant finish. But here it is in the end.
http://i169.photobucket.com/albums/u231/ch3zza_2007/DSCF1719.jpg
Nice product, good addition to all Honda's definitely worth considering. :thumbsup: :honda: :cool:
Upon arrival you get two very well crafted pieces of carbon fibre along with the required brackets, washers, nuts and screws. This kit was bought from JDMConcept and arrived in perfect condition, props for brilliant service :thumbsup:
http://i224.photobucket.com/albums/dd127/kwelrap/DSCF1673.jpg
Then you will need to drill in three holes in each canard for your brackets to be held into place with, **caution is advised**, if above all else please go to a body shop for this if you're not feeling confident as fixing cf is not a great task.** So we did some mock ups on the car and aligned the canards and bent the brackets to suit the required angle we were after.
http://i169.photobucket.com/albums/u231/ch3zza_2007/DSCF1697.jpg
We then drilled into the front bar using the mounting brackets as a guide, then with the bar off attached the nuts, screws and washers up to the brackets. All of which lined up perfectly.
Although with some aftermarket products alterations have to be made and on the one side we had to shave some of the canard off on the inside to sit completely flush with the factory front bar.
http://i169.photobucket.com/albums/u231/ch3zza_2007/DSCF1720.jpg
But in the end they mounted very well with only minor adjustments having to be made and fitted up in a little over an hour, they do make these canards for EG, EK and DC2 models as well fitting the same with a brilliant finish. But here it is in the end.
http://i169.photobucket.com/albums/u231/ch3zza_2007/DSCF1719.jpg
Nice product, good addition to all Honda's definitely worth considering. :thumbsup: :honda: :cool: