Removing the bolts on Tps sensor??

[will88]

hey guys

just if anyone knew how to remove the bolts off the Tps sensor from the stock throttle body?? cant fig out how help any1?

[vinnY]

cut straight slot + flat head
or get flat head + hammer and slowly tap it out, anti-clockwise of course

[dsp26]

cut straight slot + flat head
or get flat head + hammer and slowly tap it out, anti-clockwise of course

eeerrr what really?

i thought this was going to be easy when my TB arrives.

know the thread size by any chance? may as well get proper screws for em...

[vinnY]

it's like m5 screws or something
can't remember exactly, my tb's piled in a box somewhere hehe
get a max of 15mm though, any longer and you'll probably hit the casting

[dsp26]

it's like m5 screws or something
can't remember exactly, my tb's piled in a box somewhere hehe
get a max of 15mm though, any longer and you'll probably hit the casting
:thumbsup::thumbsup: sweeeeeet

[Benson]

Use a flat head, and place on a slight angle on the edge of the bolt.. Tap the flat head lightly with a hammer... the outer ring of the screw will break away from the middle... At this stage you can use your hand to screw out the bolt..

You'll need new bolts after...

[vinnY]

oh and searching comes up with this (http://www.ozhonda.com/forum/showthread.php?t=88344) thread which goes through everything already

even had a link to a diy (http://www.d-series.org/forums/showthread.php?t=90636) guide

[czy_sol87]

:thumbsup::thumbsup: sweeeeeet

the delsols have a hex type screw...u just need the bit to get it off
no need for cutting slots in like other hondas