Looking for custom K series mounts in eg

[Jums]

i want to make a k motor sit a little higher for better ground clearance maybe custom bonnet if it's necessary. just wondering if there are any k series mounts for eg that makes engine sit higher (least an inch) than hybrid or hasport mounts? or if it's possible to put washers or plates between them with no problems?

[EG5]

what tyre size do you run ? k24 or k20a ?

[Jums]

stock eg3 steelies i think it's 185/60-r14. got a few quotes on both engines and i'm leaning towards a k20z1 swap for $3000USD+$670USD shipping from the states cause it's cheaper but not 100% sure yet. if there's a k24a swap for that price that pops up before i finish saving up i'd definately get the k24a. planning on getting rims after the swap, 16's rear 15's front, but i'll try and keep the overall wheel and tyre size the same as it is now. was contemplating a long time between a b series for better ground clearance or a k series but i just like the k series too much. just like it a bit lowered and was thinking of putting metal plates in between mounts or get custom mounts for better ground clearance but i don't know if that'll affect anything like the headers not being able to fit..

[EG5]

get at least 205/50/15 tyres.

[Jums]

alrite