engine probs!!

[FUR30S]

hey evry1 just wanted to know if any1 could help me out with this. When i pull out my second coil off the spark plug its full of oil ive changed the rocker cover seals and it still has a leak from somewhere any1 know what it could be thanks for your help.

[bird]

does your car blow smoke when driving? could be rings or something?

[FUR30S]

yer it does blow a bit of some smoke wen pushed hard n uses oil but if its the rings i dont understand how the oil can get where it is???

[VTEChnique]

Just changed plugs in my 'new' B16A and a couple of them had a fair bit of oil in there too - but as faras I can tell it's just spashed around from regular driving and servicing over time.

clean out the oil and ssee if it comes back... otherwise dont worry too much about it.

[Weq]

where was the oil> on the electrode or the top half (above the thread) of the plug? If its on the electrode area, its ur rings letting alot of oil through into the cylinders.

Its not normal and its not a good sign... unless u want an excuse to put in some forgies :P

[Rufes1]

Im guessing its on the top half side, What engine you running? Are the spark plug tube seals part of the rocker cover gasket (im not sure). If not replace them or silicon them up..

If its on the electrode side changes are you have excessive blowby from worn rings

[ECU-MAN]

when you replace your spark plug hole O rubbers you should also replace the rocca cover gasket. did you torque the rocca down and in the right order. some twin cams are fussy. make sure you replace all 4 O ring rubbers not just 1.

[FUR30S]

its on top of the spark plug n i have replaced the 4 seals n the cover gasket. thanks 4 ur help any1 know wat could be wrong

[ECU-MAN]

did you change the rocca seal as well, how tight did you do the rocca nuts and in what order, did you cross tighten them or all down one side then the other. also what car we talking about ??

[FUR30S]

yer i tightened it up properly n its a 91 ed civic with d15b thanks again

[ECU-MAN]

I always replace the rocca cover seal when I replace the spark plug seals, also make sure you put the four seals in the rocca cover 1st , make sure their recess is clean from oil and crap, make sure the head surface is clean and flat ( no scratches or sealant )

[FUR30S]

yer there all new n tightened properly is that the only place oil could come from if so its not really a big deal is it

[ECU-MAN]

not untill your engine starts to miss

[FUR30S]

it does seem to have a miss wats that from????

[ECU-MAN]

the oil builing up in the lead tunnel causing the spark to travel through the oil to ground causing a miss

[flipmods]

As everyone said already it is most probably from the O ring seals, so just check the surface and silicon it.