Printable View
hey guys, can i run the ep3r OEM wheels on my type s (stock) without the guards being rolled?
not sure bout the offset, but the wheels are 17 x 8, and tyres are 225/45/17
Also.. what'll all think it'll look.. height wise.. since mine is stock height? btw, i got gunmetal grey , and im sourcing white rims.
Cheers
1. 225 will fit
2. dont think u need to roll the guard because +55 will sit further into the guard than ur stock which look horrible imo
the ep3 wheels are actaully 17x7.5
max you should run would be 215's, you could fit 225's if you really wanted, but it wont look as good imo
you wont need any guard work either with 215's at 2.5" lowered, thats on a dc5r. im pretty sure dc5s is the same
225 on 7.5" wide rims is good
i've seen 225 on stock TypeS rims (7" wide) and they look good too, but i think it also depends on the tyre itself
On a similar topic but not worth its own thread..
What the widest width/lowest offset a DC5 can handle?
I'm thinking of going 9+22 but not too sure if it'll scrub or hang out of guards too much? Its been lowered a bit but nothing drastic..
ive got 225 on my stock type s wheels and they look pretty good?
ive got a set of 17x8 17x9 +32 and it fits well, just depends on how low you want to go, depending on how low you go you will need guard rolling, but if your sitting high im pretty sure it will be all good with a camber kit and a good alignment!
Well I tried on some 8+30 and 9+35 and i'd say the fitment is pretty good. The 9" sits slightly further out, but neither seem to scrape.
Are you running the 9" at the front?
9 +22 will be fine at the front with a bit of camber but if you want to run a big tyre, 245 and wider, then I would go for a higher offset.Quote:
Originally Posted by Brian
A DC5 with slightly modded guards can go anywhere up to 10" at the front with 275s or 285s, and 255s aren't an issue at the rear on a 9" but I haven't seen wider than that on stock body, with rolled guards of course. I run 275s on a 9.5 at the front and 245s on an 8.5 at the rear. Works okay.
lol so fat. did it get stuck when your car tried to jump for joy? hehe :pQuote:
Originally Posted by chargeR
wow thats a bit muchQuote:
Originally Posted by chargeR
i ran 18x8 with 225 lowered 2.5inches and never scrubed think the offset was +42 but that fitted sweet.
Found a set of wheels I like, they're 18 x 8.5 +44 and I'm dropped on Eibach springs so about 1.5" - can anyone tell me what tyre size I should be going for and if these wheels will fit without rolling guards? Cheers :D