CBR250R and CBR250RR

hi there, just wanna know what are the differences in these 2 models.

thanks

CBR250RR has a different frame than 250R, engine is mounted lower down and it has a lower sitting position ,I think.. from riding experience, didn't really measure it :p

Not sure about the engine internals, but the 250RR redlines at 19,000 rpm while the 250R redlines at 18,000 rpm..

Most obvious difference is the 250RR has a twin disc brake at the front compared to single disc setup on the 250R..

easiest spot would be the double fron tdisc brakes on the RR and single on the R.

There's a lot of difference between the two models

Most obvious are the front disc brakes R single and RR dual front disc
Fairings, Swing arm and even the frame are different the RR is a totally different bike however very similar in looks

RR goes harder.

Quote:

---

Originally Posted by aramiK

RR goes harder.

---

this is bull, The torque is different on both bikes the RR has a low down torque the R is higher in the rev range.

They say that the r only revs to 18-000 but it goes to 20000 quite easily (i own one).

The RR is a better track bike because of the frame setup (for a noob anyway)

Many parts do swap over though.

but even i see this import 91, with twin disc at the front, when the shop import it, the import plate says it is R, not RR, but the shop says it is RR.

not sure if the shop is lying.

Quote:

---

Originally Posted by connorling

but even i see this import 91, with twin disc at the front, when the shop import it, the import plate says it is R, not RR, but the shop says it is RR.

not sure if the shop is lying.

---

Easiest way to tell is that the CBR250r stopped being manufactured in 1989 so if it is 91 it is an RR, Also if it has a Gull arm swing arm (not straight, goes up then bends back down) but what you are looking at is definatly an RR

Quote:

---

Originally Posted by connorling

but even i see this import 91, with twin disc at the front, when the shop import it, the import plate says it is R, not RR, but the shop says it is RR.

not sure if the shop is lying.

---

Hey how much are you paying for it ???

Quote:

---

Originally Posted by catcha

hey how much are you paying for it ???

---

$6500

Quote:

---

Originally Posted by 89_CBR

this is bull, The torque is different on both bikes the RR has a low down torque the R is higher in the rev range.

They say that the r only revs to 18-000 but it goes to 20000 quite easily (i own one).

The RR is a better track bike because of the frame setup (for a noob anyway)

Many parts do swap over though.

---

Actually im not so sure about that
i always thought it was:
cbr250r has low end torque
cbr250rr has no low end torque but revs higher torque comes later on.

but i dont like the look of the 250r, it looks old.

Quote:

---

Originally Posted by connorling

but even i see this import 91, with twin disc at the front, when the shop import it, the import plate says it is R, not RR, but the shop says it is RR.

not sure if the shop is lying.

---

could be an 87. It came with the twin front disc too.