Printable View
Ok so im pretty much finished my turbo build and almost ready to start my car/make sure everything is working/test for problems/drive it to get tuned
i was just wondering whats the best way to do this... should i put the stock injectors back in and run it with the stock ecu and the intercooler piping disconnected? the car wont run with the bigger injectors will it?
thanks guys!
P.S im bound to start having problems now that its time to start the car so stand by for questions
Go with the std ECU & std injectors.Quote:
Originally Posted by MacDiZZle
This way you can be sure it's not going to be overly rich,
Chances are it'll idle fine & give you a chance to warm it up & check for leaks etc. :thumbsup:
Thanks Adrian thats what i was thinking... wanna tune it for me? your coming up in feb arent you??
No problem... Yeah, I'm heading up on the 3rd :thumbsup:Quote:
Originally Posted by MacDiZZle
Just be careful started it though, if it hasn't been turned on in a while, turn the motor over a few times by hand just to get oil around.
Might idle rough though.
should be fine to start and drive on stock ecu and injectors, just dont go hard on it and drive like a snail.
and like above give it a few rotations by hand if not started for a while
^ By hand? I don't think you will build up oil pressure by hand.
Just disconnect injectors and dizzy and do it via the starter.
not oil pressure that will be impossible to do it by hand.
just to get oil moving a little so it coats the components
lol depends how strong you are.Quote:
Originally Posted by Chr1s
you gotta get the oil through the engine into the places where it needs to be,
not just in the head. esspecially if your starting it for the first time in a while and its got a turbo on it.
Turning the oil pump by hand will do nothing. No oil will move.
did i say turning oil pump. you turn the engine over a few times to rotate and have the oil fall into the places it couldn't get to.
the crank turns the oil pump...