As title says; I'm trying to take some part off my car but I accidently rounded the thread by using a drill since it was so fkn hard and it just slipped...
Any other way to. Take it out?
Printable View
As title says; I'm trying to take some part off my car but I accidently rounded the thread by using a drill since it was so fkn hard and it just slipped...
Any other way to. Take it out?
Dremal I line in it and use a flat head works for me most times.....
how can you round the thread? you rounded the screw or thread?
The thread/screw/grip tthing.. Not the thread thread.. Lol
u mean the screw head lol
man this guy is confusing. use chisel and hammer it if you dont have dremel, make a + or - with the chisel on the head.
Lol yes the head.. Lol sorry I'm kinda panicking loool.
Its a small screw though.. And tight ass... Will the chisel trick work?
which screw head did you round frans??
like they said make a mark heat it up and she'll be right!
Hey frans, if worse comes to worst then you can always go buy an easy out drill bit from bunnings, just ask them they'll know what you mean. Its a reverse drill bit that you can use to drill in the direction that is used to screw the screw out. And dw they're easy to use :)
instead of using flat head screwdrivers get a nipper wire cutter under the head
get some small old metal/screwdriver and weld it to the screw then twist lol