urgent hondata help!!

hi guys.

ive finally gotten to drive my integra with my new hondata, and ive noticed that its stuck in launch control. i cant rev past 4200 ? can anyone help me please

alex

ive read up and i dont have a clutch switch. and i cant log onto the hondata through my laptop cause i dont have not purchased the software, i bought this ecu off vtec1987 it was already tuned for a b18cr which is the engine in my car... so i dont know what im going to do :(

Depends how launch control is setup in your specific instance. Speak to vtec1987. You can download the software from the Hondata web site:
http://www.hondata.com/downloads.html

You can turn Launch Control off via a laptop connection and the software. Please be carefull not to stuff anything else up, if you dont know what your doing.

http://i13.photobucket.com/albums/a2...ata_Launch.jpg

i would like to keep launch control.

and i cant connect my laptop to the hondata s200 because i didn't purchase ROM editor or whatever its called therefor i don't have to Hondata serial to usb cable.

i have read that you can make a switch out of the existing clutch switch is this true?

out of curiosity could you rig up a brake light switch to make a clutch switch? and how would u do it? would it need power... only reason this is urgent is because its going on the dyno tomorrow.. :(

bump!!

actually am now beggining to think that the eu is in limp mode... will check and report back

im not much help but my hondata s300 went into what i imagine was limp mode last week after I jump started it because of a flat battery. Ran super rich and rev limited at 4000ish. soon as i got to work, stopped car, put a new battery in it, then ran fine ever since. So i think you are stuck in limp mode or at least some kind of base tune

hmm thanks mate... well my battery is almost flat cause its just sitting now

might charge her up and have another look at the connectors in the s200 box thanks :)