Printable View
Has anyone used the Victor X manifold?
how do you rate it? please leave as much information as you can.
A friend has a Worked, high comp B20 and was using the victor X manifold for a while.....
Switched back to ported type R manifold saying the victor X was too big.
constructive comments please.
the Victor X manifold on a N/A B16A type R lost power at top end on a dyno run in comparison to the stock manifoild. Dyno compairon was don on the same day.
Havn't used them but the type R manifold will make more power part throttle then victor X manifold.
Ported Type R manifold seems to be the go with built b-series.
Andy Le uses one and likes it. You sure do get a lot of clearance (I think it sits quite low). But TBH for dollar value I'd go ITR ported, which is what I've done. Better ways to spend the $$$.
I'll just use the one thats not being used. no cost.
will experiment.
is it too big for a boosted b series then ?
I believe they were made for the turbo's
Yeah Andy Le's is for turbo, engine just being run-in atm