we battled with a D16y1/D16z6 crank bolt for like an hour yesterday with the block on the garage floor - 3 guys standing on it and me trying to get it with a breaker bar and impact wrench (air gun)
any ideas on how to get it off?
ima bout to resort to using a blow torch lol
ps - i dont car if the bolt, pully or block gets damaged - i just want to get the crank and pistons out
we were considering making a small ramp and driving my 4x4 front wheel up onto it to hold it down lol
It's a bastard of a thing aye. My dad and I got mine of. On YouTube they show you how to. We sore one on their and it worked. All you need is a ratchet with big extension we put that through the rims on to the crank bolt place a block of timber on top put car into gear and got a massive steel pole. The ratchet handle goes up the pole and we literrally swung of it lol I'll send you the link
http://www.youtube.com/watch?v=7CridrQKj3E
here ya go mate good luck hope it helps
Yeah that's the one,I just saw it the other day somewhere and was like,Nice!
http://shop.ebay.com.au/items/_W0QQ_...sid=m270.l1313
Yeah we tried rattle gun and every pain in the ass. The. Saw that and just swung of it and my dad 110kg and I'm 85 and haha
yeah iv used that before while the engine is in the car ...
BUT
its just a block sitting on my shed floor - theres no weight anchoring it down
Aww yeah sorry man forgot about that
hmm try to anchor one of the flywheel bolts to a gear box mounting bolts by using a spanner.
ill try to find a pic for you.
Heres the pic (sorry spee for stealing your photo :P)
http://i109.photobucket.com/albums/n...5/IMG_1483.jpg
engine isnt on a stand tho =/
u didnt quiet understand, where the open end of the spanner is placed (this is wear one of the gearbox bolts go) put a gearbox bolt there and it will hold the spanner.
ok so that will lock the crank ... which i have already done
but i need to stop the engine from rolling over when i put pressure on the breaker bar
iv tried all manner of heavy objects short of driving my 4x4 onto it
With the breaker bar, if you try and apply leverage slowly you'll tilt the motor. With a breaker bar, get a large hammer and give it a massive smack. May take a few times but what you want to is overcome the friction holding the bolt in tight. Once you get it turned a bit, you should then be able to rattle gun it out. Give that a go!