Taking off crank pulley

Hey guys, im gonna attempt taking of my crank pulley, whats the best way of doing it ? I dont have any access to an air tool, and dunno if a breaker bar is enough. Ive just recently put the engine in, and im not keen to pull it out again just to take it off.

Thanks guys

im pretty sure you can hire 240V (mains power) rattle guns from kennards, coates hire. then get an impact safe bit , then happy days.

i guess thats the only way ? i just gave it a go, it just kept spinning :(

hey you in syd if you are come past i got air compressor and rattle gun to get it off

have a look on youtube - there are several methods
- breaker bar + leverage (using your own strength)
- breaker bar + jack (let the jack down with the breaker bar in place so that the weight of the car loosens the bolt)
- breaker bar + starter motor (brace the breaker bar and crank the engine without the ignition connected)

http://www.youtube.com/watch?v=2Zu5g95gpqo

http://www.youtube.com/watch?v=7CridrQKj3E

Nah jdm18c im in qld :(

Thanks heaps saint, ill give them a shot

just remember shocking the bolt will crack it rather than brute strength

Quote:

---

Originally Posted by Lukey

just remember shocking the bolt will crack it rather than brute strength

---

Yeah Ive learnt that from taking hub nuts off