Printable View
Ok well my headgasket blew and i decided to change it by myself :) and also TheSaint influenced me to try do it myself. I stripped apart everything and got all the way down to the crankshaft bolt in a couple of hours but after all my efforts im completly stuck, cant take it out no matter what i do :(.
Any ideas that'll help me take it out? i got no breaker bar btw.
do you have a 1/2in rattle gun with over 750nm? otherwise impact bar with the pivoting socket attachment and a nice big dead blow hammer. otherwise good luck
I got no rattle gun but i tried my mates but it was too weak and i got no impact bar too :(
What car, what engine?
i got a 900nm rattle gun but you need to transport car to me to use lol
Its a civic with a d15b and well i cant really transport the car right now cause the engines stripped apart lol
You're not in luck.
Just brute force with breaker bar or big rattle gun.
If you had a car with an engine on the other side, you could just rest a bar against the ground and then crank the engine.
why do you need to undo the crankshaft bolt for a heasgkast change?
to replace timing belt and get into the water pump
You will need a breaker bar at the very least. Buy or borrow one.
Should be able to remove starter motor and jam flywheel.
Your bodyweight should be able to crack the bolt off.
Depends if asian or not...Quote:
Originally Posted by Riceboy
lol
2m tall asian can.
http://fc07.deviantart.net/fs71/f/20...ie-d485kw0.png