Printable View
Hey guys, I was wondering if anyone has tips or instructions to remove the front badge and make it clean like the picture i have attached.
When you remove the badge there are two holes, what kind of mould do you recommend and how to go about touching it up with paint.
Thanks
WD40 and dental floss, or Hot water and dental floss works well. Just run it through all four corners and u should be able to remove it easily.
http://www.youtube.com/watch?v=uMRSPJuHW_8
I dont see a picture attached? 0.o
As for the holes maybe go to a hardware store and find some plugs that fit and just touch up? or can be professionally done by remoulding and paint over.
The badge was easy to remove, i did it and it just left some residue, just used either petrol or some good cleaning product that won't ruin your paint. Be careful when you take your badge off, take ur time and don't rip it off.
:) i left my holes cause im lazy lol
Eucalyptus oil for sticky residue, then just get it filled and painted IMO.
same lol , will be watching this thread for easy ways to fill the holes so it looks slick n clean........:thumbsup:Quote:
Originally Posted by Evok
soak in wax and grease remover, also use heat gun. this will make it much easier to remove, and the W&G remover will make the leftover residue easier to remove also.
My badge fell off during the xmas hail storm and dinted the whole car..
I went to the car when the hail stoped to see the damage and noticed the badge was on the floor???
Use a thin cable tie, always works.
Quote:
Originally Posted by IcedCoffee
Use Wd40 or Johnson Baby oil.
haha easy to be lazy lolQuote:
Originally Posted by DA9-47