Printable View
Hi guys
bout to purchase some 205/50 tyres to go on an EM1, rims with the following specs:
15x8 +20 offset
Will be on coilovers with guards rolled
Searching the thread, it looks like 195/50 looks to be a popular size... but keen to hear if anyone here that's run 205/50 on +20 offset rims has encountered any fitment & scrubbing issues?
Depends how low you plan to go man.
gameplan is to slam - no finger gap or close to
my mate has this set up on his Em1 and he needs - 4 camber on all corner and still scrubs a bit on full lock, and scrapes alot on bumps
Why not go 205 40. Thats what I had on my 16x8 + 20
Front lip around 8cm from floor. Stock exhaust around 4cm from floor. No scrub issues with these tyres. Only problem I had was my front uca smacking againts my strut tower. But that was cause I was pretty low with camber arms.
http://fbcdn-sphotos-e-a.akamaihd.ne...23523776_n.jpg
http://fbcdn-sphotos-c-a.akamaihd.ne...95361387_n.jpg
http://fbcdn-sphotos-e-a.akamaihd.ne...75950494_n.jpg
Oh wait ur 15. 40 profile might be a bit too low for ya
arrgh.. thx man - just the kinda response i was lookin forQuote:
Originally Posted by Riced_Civic
seen quite a few ppl run those tyres with +25.. but pics don't show much room for clearance at all
yeah man - cos 15" & wanna be closer to stock rolling diameter; thx for posting up da pics, car looks hot man, sits nicely - did u pull them guards of yours?Quote:
Originally Posted by PHO
Id go 195 50 personally stock camber arms will be enough if youre going around 1.5" rim to guard. My fronts are pulled out by 2cm. Rears pulled around 1cm
Thanks brah. Car is stock looking now tho. Lol
i think if you can find 205x45r15 there will be no issue..