B18c Vtech In Ls

Hi Guys/Gals,

I know there was another post about this but I want to know if anyone knows of places to get a front cut for this engine. I'm looking at getting this conversion done. I'm in Sydney, I don't mind where I get it from but also if anyone knows of a good place to do the conversion.

Thanks.

trying a search buddy..... and you wont get far here asking for VTECH -_-

i'm not in syd but by the sounds of it speak to the guys at hanny's or GPC, lot's of members here can vouch for them

search..:D

im still new 2 the whole conversion thing... but would a b18c go in2 an LS ok?

just picked up a b18c2 engine tonight, mounting the bottom end with an earlier purchase of a b16a2 head and a full rebuild with hi comp pistons and rods and whalla GSI that goes hard... hahaha if only it was that simple eh!@

im looking at putting a b18c into my car in the future future.. few yrs or so but i do have this article for you on all engines capable of being put into our gen 2's.. it is made by sum dudes off g2ic in the US but its all relevant to us still..

Good luck!
link = http://members.westnet.com.au/intenc...Swap_Guide.doc

Quote:

---

Originally Posted by __arjay__

im looking at putting a b18c into my car in the future future.. few yrs or so but i do have this article for you on all engines capable of being put into our gen 2's.. it is made by sum dudes off g2ic in the US but its all relevant to us still..

Good luck!
link = http://members.westnet.com.au/intenc...Swap_Guide.doc

---

in a few years time you would have sold ya teg for a new car.
IF by then u still have it, u might aswell go k20a as it will be much much cheaper and more readily avaliable as oppose to a b18c.

yeh but im sure a b18c will be a much easier fit than a k20a.
i was recommended to put either a b20 vtec or a b16a head on the stock b18a and then change the pistons and cams and so on.
will give u more power than just puttin in a b18c.
my mate is currenlty going with the b20 option at the moment, ill keep u posted how it turns out, if it goes well ill prbably do the same 2 mine

so how much would the LS/vtec conversion cost? and wats involved?

u'd be stupid to use a b20 head on a b18a block.

i meant b20vtec engine all together, or get a b16a head put on the b18a. 2 seperate options.
puttin a b20 head on a b18a would be a waste of time, correct

B18C type R head + B20 bottom end. ....