Anyone got the technical and how to do it yourself ? If so let me know. been searching online can't find the gap clearance from factory. Also can someone tell me how to do it on single cam.
Printable View
Anyone got the technical and how to do it yourself ? If so let me know. been searching online can't find the gap clearance from factory. Also can someone tell me how to do it on single cam.
dude
search harder :) the answer is out there
http://www.ozhonda.com/forum/showthr...ht=tappets+DIY
http://b16a2.kicks-ass.net/automotiv...tech_guide.htm
1993 Breeze
V.I.N: JHMEG331
Engine: D13B2
Valve clearances (cold)
Inlet 0.18 - 0.22mm
Exhaust 0.23 - 0.27mm
at valve
you guys are life saver thx man. ya did not search for tappets adjustment man . thx alot fot the info ECU MAN.
ecu man if ur reading just curious valve clrance can be anything in between the figure given or ie inlet .18-.22 mm?
yes,
I like to do them in the middle, more to tight side of things say for inlet
.19 or .20
kool ya i have done my car it runs much better flat spot gone
just a bump for the other trend regarding valve clarence .
Wat about a 93 Integra Vti-R?Quote:
Originally Posted by ECU-MAN