Printable View
Can the starter motor from a D16y8 be used on a B-series?
With the mounts. You keep the d16 frame mounts, its just the engine mounts that need to be replaced? So that would be rear, left, right, gearbox and AC mounts?
I have a chipped P28 in my car atm, if i just get the chip remapped with the specific stock rom for the motor i choose, ill be right?
No
Just use the ones off the b-series. i dont think all need to be changed though
Yes
All this information would have been cover on h-t, hybrid honda and the rest of the honda sites :P
it may be able to be done - but would be a lot easier to use the B series. save time and probably money in the long run. hope this helped
SO if i get the B18C motor, i need all the b18c motor mounts and all the b18c chassis mounts. so the Dc2 chassis mounts fit EK fine then?
u CAN use your D-series MOUNTS but you will need B-series BRACKETS.
A "MOUNT" IS THE RUBBER PART.. A "BRACKET" IS THE METAL PART THAT CONECTS THE ENGINE TO THE MOUNT.
to use your D-series say power steering pump or Air con compressor, u need the B-series BRACKETS.