buy the gaskets from america, $25ea instead of $50ea here in aus
i have part numbers if needed
Printable View
buy the gaskets from america, $25ea instead of $50ea here in aus
i have part numbers if needed
Tried taking our my door glass... to no avail? Any tips? I took out the bolts that was holding the glass in place, but i cant slide it out at all
Replacement radiator cap. I'd replaced the 1.3 Cusco with a 1.3 Mugen as I had a little coolant collecting on the fan shrouds under the filler - wasn't hoses. I noticed that neither was a good fit, instead of lining up parallel to the radiator when on, they twisted a little further. Bought a 1.0 genuine Honda one and noticed the grips were about 2mm longer. fingers crossed it was just dodgy non-OEM. Opened up my air-box - time for a new filter. It's ducted to the lower grille rather than using the factory resonator setup - I need to run some coarse mesh over the inlet pipe I think :)
300 bucks worth of E30 parts arrived for the BMW from the US (cheaper buying and shipping than buying in Aust) on Friday - sadly I won't have much time to play with either car for a few weeks as I have a 2 day conference coming up followed by HSC prac marking which kills my weekends.
Went for a nice sunday drive through the hills with a friend in his GTI.
This is my first Honda. so im new to all this.
Stock standard DC4 btw, only bought it last week, been very happy with it so far.
http://i49.tinypic.com/2zjg9av.jpg
http://i49.tinypic.com/4sjtjp.jpg
ED / DA Arm rest .. FINALLY .. pick it up in day or 2 :)
put my engine in. still got alot to go. i got avid racing torque mounts, which have been fine. and i also bought avid racing 75a or whatever engine mounts and they seem to make the engine notsit as straight as the oem mounts
http://a1.sphotos.ak.fbcdn.net/hphot...31591013_n.jpg
Is that a snail ?
need a new paint job badly!!!!!!!!!!!!!!!!