Did it say a minimum light output? Pretty sure I've seen that written somewhere.
Printable View
Did it say a minimum light output? Pretty sure I've seen that written somewhere.
Didn't see anything about it, those SPItints block very little light.
read this:
http://www.rms.nsw.gov.au/registrati...vsi29_rev1.pdf
specifically...
Tinted headlight covers must not be used if they cause the headlights or direction
indicators to emit a colour other than that allowed by the Regulation.
headlights must show only white light, and when on at night, illuminate the road ahead of
the vehicle for at least:
– 25 metres on low-beam
– 50 metres on high-beam.
so as long as they can still illuminate the road for 25m and do not affect the colour you should be alright.
Is a 1992 eg vti with a k24 engineered to the car illegal for p platers?
Its only illegal if you get caught.
Rather then make a new thread I thought I would just post here. As a P-plater (green), is it strictly not allowable to drive any car with an engine swap? Going from a 1.6 to 1.8, engine has already been registered to the car.
I'm reading some conflicting things. Some say it's completely not allowed. Some don't. ie.
Then again, this was from a couple years back. I just need something conclusive that's all.
inb4 I didn't search enough :(