b16a2 timing belt replacement

Snap On cordless rattle gun or a IR 1000nm 1/2 rattle gun (requires a big compressor)

dont have either and cant afford either.

is there some way i can lock it up?

yes cam locking tool

Quote:

---

Originally Posted by Lukey

dont have either and cant afford either.

is there some way i can lock it up?

---

yes. for free too.

use a flat piece of bar (steel or aluminium) and lock the flywheel... like so

http://i225.photobucket.com/albums/d...pWeek5-030.jpg

or this for auto (excuse the circle. not relevant to this but already had them uploaded)

http://i225.photobucket.com/albums/d...Pages/bolt.jpg

not gonna work if engine in stand
still very hard when engine on ground.

only way to do it when engine in stand is rattle gun.

you'll tip it over.


need this
http://t2.gstatic.com/images?q=tbn:A...RuyH22usFFrQ-A

I would not recommend doing locking the ring gear as you run the risk of damaging it

Quote:

---

Originally Posted by mocchi

not gonna work if engine in stand
still very hard when engine on ground.

only way to do it when engine in stand is rattle gun.

you'll tip it over.


need this
http://t2.gstatic.com/images?q=tbn:A...RuyH22usFFrQ-A

---

Thats funny cos I loosened mine on the stand... Didn't tip over

Quote:

---

Originally Posted by stndrd

I would not recommend doing locking the ring gear as you run the risk of damaging it

---

Whose locking the ring gear? The flywheel is bolted to the block. Not touching the ring gear

Quote:

---

Originally Posted by markismaximus

Thats funny cos I loosened mine on the stand... Didn't tip over



Whose locking the ring gear? The flywheel is bolted to the block. Not touching the ring gear

---

you locked flywheel while on engine stand and removed crankshaft bolt with a breaker bar and didnt tip over the engine?
damn i need to learn how to do this. good job mun

btw, is your engine stand is like the red or blue?

http://hydraulic-jack.com/upload/big...1291704057.jpg

http://www.jbwade.com.au/images/prod...ne%20Stand.gif

My appologies I didn't see the picture properly. Was on my phone when I posted that

neither. its like this https://www.alltools.com.au/shop/images/sz/192.jpg

I'm also not using a normal breaker bar. I'm using a special hammer impact breaker. Basically a breaker bar that is designed to be hit with a hammer. But from the top, so force is directed downwards. Tried to find a pic on google but not having much success

oh ok, i think thats the key in your success mang
im just using socket + breaker bar + extension.

i assumed you were using normal breaker bar + socket.

Quote:

---

Originally Posted by markismaximus

neither. its like this https://www.alltools.com.au/shop/images/sz/192.jpg

I'm also not using a normal breaker bar. I'm using a special hammer impact breaker. Basically a breaker bar that is designed to be hit with a hammer. But from the top, so force is directed downwards. Tried to find a pic on google but not having much success

---

You talking about these bad boys?
http://www.sidchrome.com.au/product/...ar-with-impact

http://www.sidchrome.com.au/CmsConte.../AP/2220_2.jpg