also bought those fake pedals off ebay and installed them on the weekend. Feels great! because the accelerate is bigger and longer, making it much easier to press.
My clutch one is abit loose. Same as yours?
Printable View
also bought those fake pedals off ebay and installed them on the weekend. Feels great! because the accelerate is bigger and longer, making it much easier to press.
My clutch one is abit loose. Same as yours?
I haven't had a chance to install mine yet will do them hopefully this weekend along with the headerQuote:
Originally Posted by TonyxTony
Update: So I finally got around to bring these home from work tonight, was hoping the weather was going to be good tomorrow to install these.
PLM headers.
http://i1250.photobucket.com/albums/...424_203125.jpg
http://i1250.photobucket.com/albums/...424_203154.jpg
http://i1250.photobucket.com/albums/...424_203235.jpg
http://i1250.photobucket.com/albums/...424_203634.jpg
Seen a dyno graph of these and they make more power than the J's Racing headers.
My only issue is that they dont seem to slide into each pipe without having to push and pull the ends to line up properly.
Spoon goodness :thumbsup:
http://i1250.photobucket.com/albums/...424_203300.jpg
dat fired up pedal debate..
Nice! They look pretty much identical to the kiddracing ones.Quote:
Originally Posted by JDM EP3
You can use a flat head screw driver to help separate the primary sections, then slot in the secondary sections. Again you can do the same thing to get the end section on. Its a bit of trial and error to get them to sit right. Use a mallet to help tap each section into place. I think i put mine together and pulled them apart approximately 3 times before i was completely happy with the way they sat. You can be quite firm with the mallet when tapping them together, use a block of wood on the end if your worried about bending them. This should help minimise any leaking.
How'd you go dude? Get those headers in or struggling?
Thanks man will keep that in mind for when I do them.Quote:
Originally Posted by RPS.13
Haven't actually had a chance to install them yet spent all day washing and clay baring the car today looks minty fresh and so smooth. Will try to have them in next week or the week after if I get a chance.Quote:
Originally Posted by Azz86
Cool man. Keep us posted. I'll be in the market for some headers soon :DQuote:
Originally Posted by JDM EP3
Hope that steering rack quits chuckin a hissy fit!
Which headers you goin for mate?Quote:
Originally Posted by Azz86
Not sure yet. The PLMs look the part. Looking for a bit of bang for buck. Not going to spring for Toda headers or similar.Quote:
Originally Posted by Mikeyy168
Are you running headers?
Im lookin at either t1r headers or Kidd racing ones... Not sure yet!
How much did those PLM ones cost you spaniard?
They cost $650 from BYP from what RPS13 said they are identical to the kidd racing ones.Quote:
Originally Posted by Mikeyy168