fluctuating idle and suddenly dies

Quote:

---

Originally Posted by honda_zivic

u can check the voltage on the tps, if its fukd then replace it.

wat engine and brand of the cams u installed? those cheapo branded cams have issues.

did it happen after u install the cams or already b4 that?

if u check everything and nothing works i would put back in stock cams. if issue goes away then the issue is on the cams

---

cams are skunk2 i bought them from a guy here.. it the oem cams didnt have issues

Did you check the cam thoroughly? might be a bent camshaft.

i NEED TO FIX THIS. I KEEP DYING WHENEVER IM IN TRAFFIC . EVERYTIME I REV THE CAR THE IDLE GOES LOWER AND LOWER

What car is this, what motor is in the car, how long has engine been in car or has it been converted?

Quote:

---

Originally Posted by blastnpast

What car is this, what motor is in the car, how long has engine been in car or has it been converted?

---

the car is a da9 swapped b18c. car has been swapped very recently

Quote:

---

Originally Posted by Bludger

Did you check the cam thoroughly? might be a bent camshaft.

---

cams were in one piece when i bought them. arent skunk2 products really durable?

dizzy

^ Take it to a bloody mechanic. no one will know for sure what the problem is unless they physically inspect it. if your mechanic doesn't know then take it elsewhere till someone solves it, mate. no point on asking here on a forum when nobody is going to physically inspect it.
Im just sayin'.

hey mate just letting you know i done the same thing with my car.. put cams in and the idle used to go up and down than just dye on me.. the problem was theres 2 marks on the crank pulley i had put the timing belt on the wrong way which made it too advanced so just check your top dead centre by pulling out the first plug closest to your timing belt put a long screw driver in make sure piston is at the top than check the marks on the cam gears.. hope that makes sense cause that fixed my problem for me and i was using skunk2 pro 1

check your timing.

Quote:

---

Originally Posted by sxmachine

hey mate just letting you know i done the same thing with my car.. put cams in and the idle used to go up and down than just dye on me.. the problem was theres 2 marks on the crank pulley i had put the timing belt on the wrong way which made it too advanced so just check your top dead centre by pulling out the first plug closest to your timing belt put a long screw driver in make sure piston is at the top than check the marks on the cam gears.. hope that makes sense cause that fixed my problem for me and i was using skunk2 pro 1

---

woah... thanks man!

Update: I think I know how to work the car out now. But CEL comes on and off weird