Headlight Bulb Replacement on DA9

the design of the bulb location is made for an H4H fitment. in order to fit H4, u need 2 remove the headlights, and do some cutting for them to fit.
if u do fit H4 without the modification of hte headlight, the light will be weak, as its not fully encased. i tried it with my old teg... there was light... but not enuf 2 c at nite

changing the globes is a 2 second job. The parker take up most of the time but you should of had a tool that takes the parker out. Should be with your jack. You will see what i am talking about in the manual!

Quote:

---

Originally Posted by wkdteg

http://i68.photobucket.com/albums/i5...6/Image144.jpg
as u can c above, there are 2 screws either side of the bulb, holding down the clip. like i mentioned earlier, i think it differs from series to series, as my 89 didnt have it, but my 93 does.
there shouldnt b a need 2 take off the headlights, i just did it while the car was in bits anyways.

---

Where the screw is on the right hand side of that image, you can see the metal clip going behind. All you have to do is push the clip in further at that screw (to relieve the pressure of it pushing against the bulb) and slide it out and over where the screw is.

This is how the clip is made to function. the metal clip will now swivel on the left hand screw, and you can pull the bulb out. Then just replace the bulb (without touching it with your bare skin) and push the metal clip back in and over that right hand screw.