Quote:
Originally Posted by Chris_F
yes it is! im at work rite now but i will post a pic up of it when i get home and no its not photochoped
Printable View
Quote:
Originally Posted by Chris_F
yes it is! im at work rite now but i will post a pic up of it when i get home and no its not photochoped
The insurance company wont think so when the car's in a bad accident ;)Quote:
Originally Posted by Si1enzio
Wet road handling cant be too good with such a bad camber angle.
Eibach CL9 Camber kits perform well :thumbsup:
Must handle like a brick.....
My 06 Euro is waiting to get lowered, but stock has maximum 185mm ground clearance at the rear ( the rear part of the skirt at the bottom)
....so that puts it 10mm off the road?
...no suspension.....?
Ouch!
You don't mean 7cm do you????
[QUOTE=Merlin086;1031577]Must handle like a brick.....
My 06 Euro is waiting to get lowered, but stock has maximum 185mm ground clearance at the rear ( the rear part of the skirt at the bottom)
....so that puts it 10mm off the road?
...no suspension.....?
Ouch!
You don't mean 7cm do you????[/Q
if it was 7cm i wouldnt bother with a camber kit would i and i wont b going through a set of rubber every month
crazy shit :eek:Quote:
Originally Posted by TEMPTN
I'm getting eibach camber kit for the front (they make both front and back) - you should find out how much adjustment in the camber you need to make - might be a few degrees
and btw, if you lower a euro 70mm (7cm) you most definitely need a camber kit (at least in the rear)
can't wait to see this euro with 10mm ground clearance
I think that you may be confused between mm and cm and inches.
A 10mm clearance is about yout little finger thickness.
(1cm)
A 7cm drop is about a hand width.
A 7" drop is on the ground!
Confusing isn't it.............
I have seen this guys euro posted in the other section. trust me its super low.
can you link the pictures :P
oops
im lil bit confused now.
Is this the one?
http://www.ozhonda.com/forum/showthread.php?t=55326
anna1984 and temptn are the same person? or at least they have the same car?
Ingalls Camber FTW.... Best around, easy to install and adjust!
The KMac kit is a heap of crap - I had one on and it did nothing but squeak the whole time. I bought a Fulcrum Camber kit off a fellow OzHonda member and has been absolutely perfect since i put it on a little over 14 months ago.