Printable View
Don't like tinted tail lights at all. You should remove that wing too.
http://img856.imageshack.us/img856/7687/imagetiwf.jpg
Went for a run and one of the driveshafts popped out, disengaging them both. Was so worried I'd been given a shit gearbox.
Engine is running like a dog and wont rev above 3500 rpm. Just needs a few more sensors plugged in and should be ok.
Ahh, I got told the same thing on my EK about 18 months ago and they'd need replacing soon... but explains the creaks at the back then...Quote:
Originally Posted by TranceZiggy
Can't you get an aftermarket set of Hardrace bushes - a couple of people on the forum have said these are pretty good...?
I think when I do my shock upgrade I'll get all the bushes replaced to tighten everything up once and for all.
Sounds like it's in limp mode.Quote:
Originally Posted by FAITHLESS
Not running P/S or Aircon? Or are you installing them later
Yeah it's rev limited so definitely limp mode. I'll have to start working through all the CEL's if It's still on after I've connected everything and reset the ECU.Quote:
Originally Posted by dorikin
No P/S or aircon. Car came without air con from factory and I'm after a B16A2 P/S pump and bracket. Or perhaps a B18C power steering hose.
Your EK hose should connect up to an obd2 B18C pump too or any obd2 b-series pump
Quote:
Originally Posted by TranceZiggy
hardrace are fine from what I've read, ill be using them when I start redoing my bushes, if your worried tho you can get oem ones fairly cheap from oem Acura parts or lings, think the part # is 52385-S21-003 for the updated one or 52385-SR3-000 for the old oneQuote:
Originally Posted by Alvis
install yourself to save even more
www.ozhonda.com/forum/showthread.php?131967-How-to-swap-your-suspension-bushes.-Rear-trailing-arm-Front-amp-Rear-LCA.
Ok that's good to know. Thanks.Quote:
Originally Posted by dorikin
installed so new stuff on me car
http://i786.photobucket.com/albums/y...m/IMG_3064.jpg
Ultra racing 3 point strut tower bar
http://i786.photobucket.com/albums/y...m/IMG_2978.jpg
3.5inch shift extension and mugen replica pedals
where abouts did you get the headers from, and what brand are they?Quote:
Originally Posted by CivicRacer13
there just cheap unknown brand headers from ebay,had the gasket blow where the 4 goes into 2 after about 8months since i put them in,couldnt get a gasket for it so i welded the joint together and problem solved and the colour turns shit after a few runs but thats just the cheap stainless steel i guess haha
Quote:
Originally Posted by Niko
Progress is slow, but getting there.
Shaved rear boot and wing
http://img571.imageshack.us/img571/3360/photo16cc.jpg
deleted my B pipe muffler and put a new exhaust tip on it, all done at home, took it for a drive running only on extractors sounded like a monster truck lol