Printable View
I have a contact to get the car all engineered up and have the cash, but at the moment the next job is replacing all bushings, balljoints etc and renew the suspension setup. Engineering is the next step after that. SA is a bit different than the other states in that we dont have inspections, just cops can pull you over. In 11 years of driving a modified car that only happened once and he let me off anyway, didnt believe me when I told him it was a '91!
these things are a pain to get here in aust mine came from canada lol havnt seen another DA with the sunroof visor yet but its functional when it rains etc unless u break then water falls inQuote:
Originally Posted by vuonguz
holy s**t rocky where u been hahaQuote:
Originally Posted by kikxz
ive been in isolation lol got quiet on the forums n stuff so i once in a while skim through things haha how have you been man?
haha fair call, yeh not bad
grey da9 got written off so now im crusing in a burgundy da6 haha
alot of work on the books too shud be good
how bout u?
shit man how the hell did that happen? haha are you gona build the vtecaaaaaa or are you slapping the b18 into it....
Yeah my car just got back onto the road after a bloody defect screwed me over hard so now its back to semi stock for the time being lol
haha im slappin the b18 bro, vtec gettin me round for now, loud, but i want the torque the b18 had haha
there was hard brakin infront of me, i stopped just in time 10cm of bumper of guy infront, chick behind me didnt, rammed me hard, sandwiched into next guy, then he got pushed into next one
but my engine and shit was fine, so im buildin that more atm, while i vtec it haha
Hey Stevo, your inbox was full so I posted on here hope its ok...
I just had a look and their website has all the different variants and their dimensions including the dimensions of the control unit near the top of the page. just make a mock up out of cardboard and see how it fits..
http://www.xforce.com.au/about-varex...ts-muffler.php
yeh soz dude, it gets full soo quikcly when u start sellin stuff lol
thanks man will do
hmm the actuall muffler one looks interesting, it might fit where the current rear muffler is, just height is rele the only prob
edit* ok lil more research later i find out its 220mm in height from the motor
basicly height clearance is my prob, ill have to see how tall the stock one is or how much room in the chassis
but it rele wet right now outside and dark so itll have to wait haha
yeh ive got the 2.5 inch inlet and 4 inch outlet varex cannon waiting to be put onto my car it should fit as the motor isnt that big the whole cannon is almost normal size
let me know how u go man,Quote:
Originally Posted by kikxz
see if u get many scrappy probs, like ground clearance, goin into drive ways and stuff
lol i did with the old cannon man same size but that was ridiculous low it became flat on the bottom... but if you set it at a normal height you would prob receive scrapes man but ill let you know