driving experince is so much better thoQuote:
Originally Posted by Mugen_B16B
no more wheel hop
shifting is a gazillion time better
Printable View
driving experince is so much better thoQuote:
Originally Posted by Mugen_B16B
no more wheel hop
shifting is a gazillion time better
Mugen, you said that you once replaced the mounts with the DC5R's ones. Did you change the whole lot?Quote:
Originally Posted by Mugen_B16B
if it was, then that means that DC5R has this problem as well and needs to change the mounts often.
dc5's have this problem as well...Quote:
Originally Posted by blk_shadow
Main problem with the mounts is actually the rear and passenger side. They passenger side one is the weakest, therefore putting alot of pressure on the oil filled drivers side.
I have some 62a ones and hated the vibrations. So I recently reinstalled stock one filled with urathane and is performing very well.
Many might say its dodgy but It has held up very well with a few hard launches at the drags. Trick is to fill them properly and give it time to cure!
Each to their own, but I just couldnt stand the vibration. Rather feel the loud exhaust ;)
anyone know how to disable the annoying ignition beep?
The engine bay seems rather dirty.
Is that what happens with a shot engine mount?
Hey Guys,
went and got my car dyno'd today and got a respectable 123.9kw atw pretty much stock with a 5zigen exhuast from the cat i think
this is my base dyno sheet im hoping to improve on this in the near future
Thats about right. Dead stock is around 120 give or take a couple!Quote:
Originally Posted by KaZe86
Quote:
Originally Posted by KaZe86
thats sik..... at atless you know your k20a is in good cont!!!
yeah i was looking at 120 but yeah thats seems to be good for now ;)
it might have been covered here, but can't find it anywhere..LOL
is DC5 and EP3 shares the same coilvers?
cheers guys
not bad bro...:DQuote:
Originally Posted by KaZe86
95% Same. You need to use DC5 tie rod ends as the EP3 ones are smaller and shave about 4-5mm off the rear lower eyelet to fit!Quote:
Originally Posted by blk_shadow
Whats wrong with your aragosta ones??