would you need any eng cert doing a spot weld on the chassis?
Printable View
would you need any eng cert doing a spot weld on the chassis?
is this for a race car or is this for your street car? what are the future plans for the car? if u feel its a must, get a professional welder to do it, but if you realy must diy please consider doing a welding course first, if u really feel its needed for your application. however let me say its not hard to screw up, and self inflicted dammage is not covered by insurance. please be careful.Quote:
Originally Posted by spetz
what other mods have been done to your car? id say theres probably many other areas to address first before going into spot welding. Foam filling can get messy but gives excelent results. if u go this route, get the foam made for the job, not the hardware store stuff.
Yeah... then they wrecked it by putting a cage in it that is worthless. :rolleyes:Quote:
Originally Posted by Limbo
If you ever stumble across pics of the front part of the cage and how it has been bent to contour with the dash..... you will know why I said it is worthless.
Hmmm... Bending the roll cage to contour with the dash actually can malke it stronger if welded properly. Check out a WRC car next time you have a chance and notice that their cages are curved around the dash too :)
There is an big science behind roll cages, all depends on what you want to achieve. If they wanted the mounting plate to be in a certain part of the chassis and wanted to keep the dash, then that is the compromise. Properly bent pipe should not loose its structural integrity.
Compromise is what ends up costing people their lives when it involves safety. :rolleyes:Quote:
Originally Posted by iamhappy46
All those hi-speed WRC crashes into trees/off cliffs seem to highlight that I assume? ;)
All depends on the A pillar position and where the strongest part of the floor is, not to mention class rules. Got evidence that a properly designed curved roll cages kill/injure more people than a 'properly' designed 'straight' cage?
Keep in mind that curves are used in the B pillar braces as well :)
Anyway decided that I'd get a pro to do it
Not that expensive either
After I strip the hole car and drop it off should be under $1k and then just gotta put it back together myself
cool:thumbsup: wise choice.Quote:
Originally Posted by spetz
I am not talking about curves. When you have pipe that has been bent pretty much into an S like seen on the front section of the cage of the car that was mentioned, that pipe is easily going to collapse with the forces experienced ie. in a roll over.Quote:
Originally Posted by iamhappy46
SPETZ: Take it to a place that have done CAMS approved cages before.
Can a smash repairer do it?
Is it worth doing for street car?
Does he or has he made cages that are CAMS approved based on the the rules and guidelines the type of racing the car will be competing in? If yes then yes he can.... if he hasn't I would not even waste my time further asking them. Even though it seems the car will not be used in motorsport of any kind I still would not be adding something in a car by someone that just knocks one up cause he is good with a MIG and pipes.Quote:
Originally Posted by spetz
"Is it worth it for a street car?" ...You mean a cage? IMO NO.
Though the idea of more welds, spot welds and seam sealant/joiner I would say it is possibly worth it, BUT only if you already had plans on getting the car totally resprayed.
Actually, the Cusco ones, even the curved ones are actually ok and approved in Japan for Motorsports.
CAMS approved only if you intend to race in Australia...thats only because CAMS are being an arse about the whole "I make the rules thing", not because they're any safer.