Aftermarket Headunit

looks pretty nice tho

so anyone have any contacts in getting the JDM FIT center console to suit a single din HU??
i have contacts and part numbers...will have to call up tomorrow
anyone want any?

It's the same thing but you just add a pocket to make it single DIN...there is no big secret to it.

Quote:

---

Originally Posted by Tofu

so anyone have any contacts in getting the JDM FIT center console to suit a single din HU??

---

they dont have for a single H/U, but as "Jus-10" mention what u need is just an original honda pocket, same as i did on the jazz with TV screen one, but the pocket its on top of the screen so when its open u cant see the pocket, because i dont want the air from the A/C blow direct to the back of the screen if i put it the H/U on the top part, and its not really good for the LCD screen

oops...my bad
i mean for double din

aka_nsx
do you have the part no. for the pocket?

Pete :)

Quote:

---

Originally Posted by petrovski

aka_nsx
do you have the part no. for the pocket?

Pete :)

---

if u r in syd, I reckon just call honbit / hontoys for a pocket, basically
you can use any pocket as long as honda one,
thanks

If anyone wants the aftermarket dash parts for their jazz pm me for details by this Friday 3rd september!

Pm's ONLY!

Pete :)

aka nsx, where abouts did u run the wires through the firewall? near the battery where two pipes run thru the gromment? or nearer the driver side where the relayed power goes thru? i tried the latter but i couldnt make the grommet budge! any tips?

honestly i can't remember which side but usually i run the cable the one that close to the battery, and the grommet its a little bit hard to push you need something very pointy, remember if you make the grommet bigger DON'T FORGET to put silicone otherwise water might go in . . . . .

i just ran it thru the hole on the driver side where the fused power goes in. Im not too worried abt water goin in...cos if there were *that* much water in the engine bay id be in trouble anyway...but the grommet does keep out a lot of engine noise. moral of the story: ghetto way of hearing more engine/ pretend-induction noise is to remove the grommet.

hi guys

just joined the club few days ago and would like to find out more about the aftermarket headunit conversion.

how much does the panel cost to be delivered to brisbane?
is it going to be an easy conversion?