Creaking clutch pedal [Euro]

My creak is back... And on my third MC... Don't think I'll get it replaced under goodwill now since my warranty period is over...

^ If its a common issue and you can prove it (give them a link to this thread for example), they should cover it as goodwill.
Its an engineering fault Honda should have resolved by now.

Quote:

---

Originally Posted by EuroDude

t1234 you should lube it anyway to avoid it. The 06 Euro has the same issue as previous years. The problem is once it dries up and starts creaking, it will never be the same again. Spray some silicon grease into the piston above the clutch pedal ftw

---

Took your advise and sprayed it with some silicon spray 15 mins.ago..........thanks.:thumbsup:

^ No worries, spray it once every few months and it should be fine :thumbsup:

good advice. When I got my third MC I sprayed it every now and then (before the creak) and it hasn't come back. Touch wood.

There are 3 supersessions for the euro clutch master cylinder the latest one should fix the problem part no. 46920S7AA03.

I've also resorted to using Lithium grease to rid the irritating creak LOL!

Hi Aaron,

Can you (or anyone else if they've already done it) please post the picture of where to grease the slave cylinder from accessing via the bonnet? I've done the the greasing of the hole behind the clutch pedal but can still hear the creaking inside the engine bay.

Thanks!

Quote:

---

Originally Posted by aaronng

That's the clutch release fork bearing. Different issue to the creaking clutch pedal, but good luck. All I did for this problem is to lube the part that comes into contact with the slave cylinder with some high temp lithium grease. The bulk of the squeak comes from inside the gearbox, which I can't access from the outside.

---

^ the Slave MC should be attached to the gearbox, you need to pull back the rubber cover to access the piston, then spray into it.

It's just below the intake manifold. I greased the point where the slave cylinder makes contact with the clutch release fork. I didn't grease the piston itself.

Well, it's happened to me too now.

Creaking clutch pedal started about a month ago. The car was serviced yesterday, and they've ordered a new master cylinder... at just under 17000 km.

It's not the master cylinder's fault as someone with an 07 had the master cylinder replaced but the creak came back. I'm guessing it's the spring that is on the push rod inside the firewall cavity. Probably depends on the amount of grease they use when putting in the new master cylinder.