WRENCHIN' WITH TRAV - Header Install

Quote:

---

Originally Posted by MrPlow

trav man, we not digging on you... im very thankful of your write up and post up of the dyno chart... just trying to get to a reasonable power gain figure....

relax champ, your work is appriciated!

---

ok man, it just that a got a very hard time from EVERYBODY just about and BAH! i got cranky. sorry. :(

this is the first of many dyno runs so ill keep workin at it.

thanks man. :)

Quote:

---

Originally Posted by egSi

ok man, it just that a got a very hard time from EVERYBODY just about and BAH! i got cranky. sorry. :(

this is the first of many dyno runs so ill keep workin at it.

thanks man. :)

---

wtf trav u big girl.

Try being pushed into "dynoing" your totally stock car on a dyno day ( with like 40 other cars) - only to be the lowest on the day by far ehehhe.

Its all fun mate .


Now remove those headers and dyno that thing again for a comparison !!! :thumbsup:

Quote:

---

Originally Posted by bennjamin

wtf trav u big girl.

Try being pushed into "dynoing" your totally stock car on a dyno day ( with like 40 other cars) - only to be the lowest on the day by far ehehhe.

Its all fun mate .


Now remove those headers and dyno that thing again for a comparison !!! :thumbsup:

---

bah, i paid of over 2 times what it costs in brisbane to dyno

Quote:

---

Originally Posted by egSi

bah, i paid of over 2 times what it costs in brisbane to dyno

---

how much is it up there ? Normal ( not group buy etc) is about the $80 for 3 runs i think in Sydney ?

i paid $70 for 3 runs and i have been told(yesterday) it was 25 for 2 runs in bris. :confused:

Haha man that was a once off for $25. Sorry dude. I must have mislead you the way I said it. :o

That's average price you payed!

BTW...... how flat is that torque curve!! Is this a usual thing for D's? Such flat torque curves?

Quote:

---

Originally Posted by SPEEDCORE

BTW...... how flat is that torque curve!! Is this a usual thing for D's? Such flat torque curves?

---

ahh...wrong again.

Trav hooked up a sensor or two to his croutch.
Its actually a readout of his "d series arousal" bwhahahahah :D

Quote:

---

Originally Posted by bennjamin

ahh...wrong again.

Trav hooked up a sensor or two to his croutch.
Its actually a readout of his "d series arousal" bwhahahahah :D

---

word, ur such a tech head ben

Excellent write up. I wish my JDM headers bolted straight up to my exhaust as is, however some cut and weld is needed, otherwise I would have followed this extremely detailed DIY. Keep it up!

u should use the ring end of the spanner to undo the oxygen sensor ;)

take your x-force off and put your old exhaust manifold back on and do a dyno so we can get a real gain figure :D:P
JK man :)

Quote:

---

Originally Posted by tinkerbell

u should use the ring end of the spanner to undo the oxygen sensor ;)

---

i tried man, wouldnt get on there was not enough room between nut and the manifold, ring spanners piss on open-enders man ;)