for the VTIR's you can get a special tool to set the clearances along with fealer gauges.
you can also use a 10mm socket and extentiopn bar on a 3/8 breaker bar, but its more of a pain, but it works.
Printable View
for the VTIR's you can get a special tool to set the clearances along with fealer gauges.
you can also use a 10mm socket and extentiopn bar on a 3/8 breaker bar, but its more of a pain, but it works.
for me I had a spare 10mm spanner lieing around, so i heated it up red hot, then bashed it over a brick to get it to curve up. Then i re bashed it over on the other side to turn the originally strait 10mm into one the resembles an
.....|--C instead of originally a O------C
.....|
O--|
this is what it looks like
http://b16a2.kicks-ass.net/tech/tappet-tool.jpg
they are not cheap.
you use the socket to undo the nut, it should only be loose enough to be able to just move the screw inside. set the tappet clearance and nip up the nut. check the clearance, if its ok, move on, if its to tight you have to loosen the nut then back the screw off abit then do up the nut then recheck. just keep doing this until you get it right.
takes a bit longer but defantly doable
TUBE SOCKET/SPANNER FTW!
http://i7.tinypic.com/63inq1l.jpg
cost me $12 from total tools.. put the screwdriver through it and use a spanner on the other end to turn the nut
This DIY is reccomended. Very easy to follow, thanks ECU-MAN. Gave it a go on the weekend and worked a treat, Shut up my tappets and motor feels 'tighter'. yay.
One question though, Can u clarify the TDC mark on the harmonic balancer? Is it the single little hole on the circumference of the smallest ring of the balancer?
no its the single mark on the circumference of the larer ring of the balancer.
usually a white mark, the timing mark is a red mark between two marks.
Ill see if I can dig up a picture
oh no... could i have screwed it all up then? i didnt use what u described. car seems to run fine though..
did you line up the cam on TDC of Cyl #1 and #4 like in th bellow pic
http://b16a2.kicks-ass.net/automotiv...appets/064.jpg
yeah i could match up all the markings on the cam gear no problems..
but there was no markings on the balancer..a few holes here and there on it, thats it.
as i followed the intructions, each set of tappets that were next to adjust were loose like u mentioned. like i mean the #1cyl set were loose, adjusted them, turned crank and #3cyl were loose.. then 4 then 2. hope u get what i mean.
car run better though it seems... cant have gone too wrong i guess..
sounds like you will be fine
good work