yyes. most of us got it from ebay.Quote:
Originally Posted by mr747
Printable View
yyes. most of us got it from ebay.Quote:
Originally Posted by mr747
If you buy it from ebay, they send it by EMS, so you might get it if the payment goes through quick.
rofl tomorrow is tuesday.....
tuesday next week, not tomorrow.. but yea a week is asking a bit much hehe
hooyn: sitting on buddy club N+ and as for height ;) wait and see buddy!!!
worst case is i go negative camber for a few weeks hehe
fulcrum camber kits?? they got a good rep??
shouldnt be too bad 1 week wont hurt unless you thrash it around, yeh sorry misinterpreted.
hopefully my mate can get me lowered on this saturday if possible.... been waiting a while.... *sigh* so excited....
1 weeek or 2 is ok. I was without a camber kit for over 2 months.
are these the ones http://cgi.ebay.com/ebaymotors/Ingal...spagenameZWDVW
lol AARON, why the delay in getting camber kit? and how was your wear in 2months?Quote:
1 weeek or 2 is ok. I was without a camber kit for over 2 months.
You only need the rears. I don't like the front balljoint type.... Prefer the A-arm type like the Vision front camber kit.Quote:
Originally Posted by mr747
This is the rear kit that I bought (exact same seller that I bought from too): http://cgi.ebay.com/ebaymotors/03-HO...QQcmdZViewItem
I had to move from Sydney to Melb. So I bought it only after I got settled in. The tyres were worn on the inside shoulder, as if someone had taken a knife and shaved off the tyre shoulder. LOLQuote:
Originally Posted by Crapdaz
arrong where do you get the fronts from???
Check if any of the dealers sell Vision products. They also make the same part for spoon.Quote:
Originally Posted by mr747
http://www.spoon.jp/eng/database/details.php?id=932
http://www.spoon.jp/eng/database/details.php?id=933