closed!
Printable View
closed!
no...
this would be easier,
http://www.offbeatearth.com/wp-conte...se-458x346.jpg
Actually with customisation it's possible, you just need to fabricate the radiator support, then customise the guards.
If your talking about a straight swap, answer is no.
If your asking if it's 'possible', then yes..With customisation as Tony stated.
The front end would prolly cost more than the car itself LOL
Lines will all be wrong to. Eh is a box, teg has curves.
fibreglass, time and funds will be your friends :D
do it! on the cover of an old hot4s issue, it had a EH civic sedan, with the AUDM ITR front end, and it looked quite kool, so naturally a JDM front end could be done aswell
just need a welder and grinder
some one do a photoshop
as every1 said... money... thats all u need... if u got money then yes... if not then dont bother... over in the states theres some em1's that have done before ask them since their freaks n all
been done on heaps of hatches in indo
like like lan said its just weld and grind
http://i5.photobucket.com/albums/y16...ONTEGhatch.jpg
http://i5.photobucket.com/albums/y16...HATCHCIVIC.jpg