i have jap spec crx it has the zc twin cam mill in it is the motor the same as the oz spec early integras??
Printable View
i have jap spec crx it has the zc twin cam mill in it is the motor the same as the oz spec early integras??
i think so - can anyone confirm?
why do you want to know???
Yes, also same as Rover 416i (integra 4 door) and Si Civics circa 83-93
cause i have spun a bearing in my car now and need to replace the motor my mate has a early integra at his wreckers with an zc twin cam so i just want to make sure that this is the right engine and will fit straight it
yeah - should bolt in :)
better off getting from a same car...
it's just like the AU b16a and the JDM b16a's parts r different...
cuz higher compression and so on..
i suggest u get the parts from the same car..
is there a vtec motor that will fit straight in??
B16a should, the mounts are OEM, shouldn't be hard to buyQuote:
Originally Posted by COZMIC
have you got a rough idea on how much they are??
no idea, do a wrecker ring around. I think from memory the EF civic SiR mounts are exactly the same. I think the EG SiR and CRX mounts are slightly different, but would probably do the job with a little coersion.
You can't just drop in a b16 into that car. You have to think about wiring harness and ECU etc.
So unless you are prepared to do that, then just stick with the ZC you have found.
Engine will fit, wiring will not....Quote:
Originally Posted by COZMIC