Printable View
at the back of the intake manifold (which i've taken off the engine block) there is this white sensor, it's screwed onto the intake manifold and i cant get the damn thing off..
i cant use a socket wrench coz it's a screw
i've used a crap load of degreaser and the biach wont come off..!
i wanna clean my IM abit, hose it down and such so i wanna remove all the electricals/sensors...
....or...do i need to remove that if i want to hose it down? i'm guessing i would
id use an impact hammer,
is it the IAT sensor your talking about ???
not 100% sure which one it is
it's the only white sensor on the back of the IM
whats an impact hammer do?
i've heard of impact gun but not hammer
its a handheld device that has a 3/8 head on it, you put a phillips head drive socket on it, put this thing on the screw, and hit it with a hammer, it will give a sudden twist as you hit it, cracking the screw
supa cheap sell them for about $30,
I got a really good one, works a bit better than a cheep one, but unless you use it as much as I use to, juct get a cheep ass one, or even better borrow one if you can.
i've got an electric drill (not the weak cordless one)
would that do the same thing?
nope
ill take a photo of one for you
ok thanks...
any chance of me being able to give it a spray down without removing that?
shoud be ok,
hehe
"should" kinda scares me....
hmm, yeh i'll try get it off otherwise might just cover it on the top somehow...
http://b16a2.kicks-ass.net/pics/impact.jpg
you hit the end with a hammer
ahh ok, do, how do these work better than normal screw drivers?
looks like the same white plug but diff. location