Printable View
hi i found a site that is based in nsw it has a turbo manifold and im not sure about it. the site is! http://www.tweakit.net/shop/product_...oducts_id=6614 i live in perth just wondering is there any 1 out there that can help me i want to put a turbo in my 1990 integra b18c and i want good quolity stuf that wont blow up on me
bit expensive but looks fine, find out what brand it is & if you can keep your a/c & P/S. What engine do you have?
He has a B18c
well the manifold looks fine, just depending on what type of setup you want.
i.e drag car, track car or daily driver.
The you start building depending on your like.
that manifold is rather expensive, you can get a stainless log type manifold from the states for around $400 landed. Cast ones prolly for 300ish.
That manifold will be ok for up around 160kw, if your looking at making a monster, go with a quality piece like a full race ramhorn, peakboost, neukin etc (there over $1000 tho)
yea i want a alrounder and a car that will break loose i want to see the face on the commodore driver as i fly past him hahahaha o and i will be using it as a daily driver
i found another turbo kit from full race http://www.full-race.com/catalog/pro...e5d92788c59aed was thinking that do i need to do anything else to the motor so i will know my motor wont blow up
ok based on my build, keep under 10PSI and you'll be fine with a stock motor.
being a 1.8ltr i'd say somelike a GT28RS or a GT2876.
Got a friend who has the GT28R on his 1.8 and its little small.
Should be able to make around 160kw atw with that turbo and that's enough to daily drive and smoke v8s
that turbo is too big, opt for a disco potato/gr28rs/gt2871 or gt2876 this will easily get 160kw and then some later on.
You will need injectors around 550cc's
and ecu like hondata s200/300.
possible clutch and flywheel upgrade and 2.5 to 3:" exhaust
if your keeping it simple get a log type ss manifold if your not getting forged internals rods etc .
spare 5-6g to do a nice conversion.
well i dont mind geting that stuff i was going to mod as much as i can i was thinking about geting the ecu injectors flywheels and the heavy duty cluch install at the same time and i say the 3" sounds good to me hahaha
i just need to find this stuff can you help me where can i get them
dunno any place in perth sorry mate