can anybody tell me where the OBD is located in the EK ive looked all over the place but no luck finding it or im just blind and other forums havent been very helpful as most of em are US or UK forums
any help would be much appreciated
cheers
Printable View
can anybody tell me where the OBD is located in the EK ive looked all over the place but no luck finding it or im just blind and other forums havent been very helpful as most of em are US or UK forums
any help would be much appreciated
cheers
if your talking about the OBD2 Diagnostics connector AUDM dont have it
only the 3 pin DLC connector
Is the 96 EK1 even proper OBD2?
its OBD2, but doesnt use the regular connectors that Honda uses for OBDIIa and b.
its behind the left kick panel
Hi Guys,
I'm new to Honda's and I have a 98' compliance plate but 97' built Civic Gli sedan.
I've been trying to find the OBD connector but still can't find it. I found HondaHookup.com ages ago and they insist it's an OBD-II model and that the connector is under the dash near the steering column LINK
I have just about pulled the entire dash off and still can't find it..
I have pulled the left kick panel off but I'm not sure it's there ...
http://i24.photobucket.com/albums/c4...llo_CivicH.jpg
http://i24.photobucket.com/albums/c4...llo_CivicC.jpg
HELP!!!!!
Also, after downloading the full service manual and bleeding the clutch I now have what sounds like a rubber squeak when depressing the clutch, any ideas.
Also I have a whistle type noise when I am at about 1/3 to 1/2 throttle under load. When I give it more throttle the noise goes or when I use less.
Car is perfect only ever serviced by Honday dealer. I brought it at 70k km's and it has only just ticked over 100k after having it for about 2 1/2 years.
I only use Honda parts for the car... Anyone know of a cheap place to get trade on parts. I was using a guy in Melb but I think he is telling me crap about getting trade...
your car will not have a OBDII port. Australian cars didnt get them until 2004
in the red cirle you have the 2 pin SCS and 3 Pin DLC connector
http://b16a2.kicks-ass.net/tech/Willo_CivicH.jpg
Thanks ECU-Man,
What are the three letter acronyms? What would I use to check engine codes?
short the small blue connector with a paper clip or something. theres a diy guide for it here. do a search:thumbsup:Quote:
Originally Posted by Willo
Thanks guys. What does SCS & DLC mran?
It's time for someone to use google.
All those simple questions,google can answer,the trickier ones,the guys will be more than happy to meet the challenge.
So from what I have found one is a Service Connector and the other is a Data Link Connector???
I'm still none the wiser, why there is two. I can only assume one is for checking the ECU service codes and the other is to program the ECU???
Is there a way to get a bit more out of the ECU?
no,
DLC is for Honda HDS or PGMFI tester, you can also get aftermarket readers that connect to the 3 pin DLC
the SCS is only for reading codes and setting the ignition timing
sorry to dig this up but are there any conversion plug to turn these 3 pin DLC and 2 pin SCS into OBD port ??