DIY: Get that lip sitting straight.

Ok,this is simple as,but some things are and until you see someone else do it,you ignore it,it slowly gives ya the shit's.Then you see this and go,offcoarse,easy,why didn't I think of that...hehehe

So,it's just long bolt up through the bottom of the lip and through the bumper.Held on with a lock nut and washer's to stop the head of the screw and/or nut pulling thrugh the plastic :thumbsup:

http://i99.photobucket.com/albums/l2...2/IMGP2318.jpg

http://i99.photobucket.com/albums/l2...2/IMGP2319.jpg

Mmmm Straight :p :D

http://i99.photobucket.com/albums/l2...2/IMGP2317.jpg

Offcoarse,the same for the front.If,for some reason it sags in the middle,just stick one there :cool:

doesnt look straight....
.
.
.
.
.
.
jk.

hehehe,it's decieving huh :)

bumps

haha nice, i did this with my front lip to get it just right - i hate lips that dont fit nice and straight but angle up and in all directions lol

with the muffler that close, does it melt the lip at all?

It dosen't Vinny,there's a good 1cm gap there and it's sweet.

nice diy

Thank U!

thats a really simple, 'think outside the square' DIY. i will do this to my mates rear lip, which has exactly the same issue.

Thanks Jeff!!

nice thinking brettles, now get on to the track, that lip is going to give u 5kgs of aero downforce :P

hehehe

barmP!

nice twin loop

and handy diy too :)

Thanks Kraiye!

Cable ties > Screws. :P

That would work good too!

:)