wat error code is this d16y8 93 EH

[YOUTUBE]NzfLwAdeFzY[/YOUTUBE]

i thoguth it was 3 but its 3 long flashes

that is code 3. Those are 3 short flashes

*typo*

AWWWWWWWWWWWW lol,
so wat exactly shoudl i do now

look lyk its code 3

code 3 is map sensor not 02 sensor.

Check ECUMAN diy, that would help u

yup MAP sensor (ignore my typo)

check to see the clip is firmly held to the MAP sensor. IF so , replace with a known working MAP to see if that fixes the issue

make sure you havent got the TPS and MAP connectors crossed


http://www.ozhonda.com/forum/showthread.php?t=67230

crossed?

in what way ?

he means they are plugged into the wrong sensor.

mmm are the plugs the same? geez i better check this now

yeh they are both the same, but most likely if they are both mixed up, then u should get 2 codes which is 3 and 7. You only have code 3, the problem most likely be the sensor.

Did u just do a conversion ? or u been driving same motor for a while?

did change motor to the same it had cause the other blew.

and am only gettin error 3

so i should change the map sensor i guess for now

yeh get it changed and remember to reset the ecu after u changed the map sensor

k boys,

so i serviced the car too, reset the ecu too

so far ... i havent driven it long distances but

after resetting the ecu wen i do the diagnosis it shows me nothing only thing is the engine light stays on. is this normal?

if the TPS and MAP are crossed you usually only get one code ( 3 ) not 2 codes. then TPS is still in range when they are crossed.

so atm, im not gettin any errors. i went for a drive last night and fanged it a bit just to make sure everythin was ok

cars still not boosting but it seems to be driving better than before tho.

oiii big boys

so am i all good for now since its not giving any errors?

is that the signal for everythin bein ok ?

the light stays on ?

yes, ur all clear

phew sweettttt

i

are you running a modified ROM that supports boost ?

not sure wat rom means ?

chip in the ECU

aw im runnin a emanage.