Printable View
EDIT: pic should work now
I've linked a pic
I just havn't seen this bar anywhere, it's only on the car while i'm fixing up the aftermarket front bar, its been scraped a few too many times on the bottom ;)
i'm assuming its meant to have a grill or something in the opening, but when the car was bought, it was given to us as the original bar?
This is a sedan by the way
http://www.hostmyimages.net/u/04/330/20/PIC00118.JPG
no pic bud
fixed ;)
that looks aftermarket...but you could just go to a panel shop and see what a powder coated mesh insert would set you back
yeh thats what i thought at first, but its not made from fibreglass, its made from that ABS plastic or whatever its called?
heres a pic of the aftermarket one i'm fixin up, just thinkin tho, that "stock" one dont look to bad, and its a couple cm's higher, might be more convenient (hafta get it sprayed tho) to have that, the car will be more than 8cm off da ground too ;)
http://www.hostmyimages.net/u/04/330/20/PIC00070.JPG
ey that's a hype front bar.
used to have it on my EG
which bar danny?
isnt that first pic like a sedan bar but with the centre grill part cut out?
first pic is a sedan bar with no grille
second is a hype bar.
danny do you know what the hype bars are worth, where they come from and if they make a full kit?
Cheers
im pretty sure the 1st pic is the oem eg sedan without the grille, but pls correct me if im wrong
anyone got a pic of one with the grill?
the second one makes that EG look like a Hyundai.
n the 1st one makes it look like a 99' Lancer Sedan ;)
yeah 1st is def factory bar with grill cut out. for some reason they cut out the middle part in the grill which goes across :thumbdwn: . get some mesh into it and it should look a bit better. or just get another factory front bar. looks better than either picture
the second bar looks aweful im with skOota, makes it look like a Hyundai
the first bar is a OEM eg sedan bar with teh grill bits ripped out.
each to their own i guess! and its a possibility of fixin up the oem bar, spraying it to match the car properly and meshing it up, shouldn't look to bad! and wont need to repair it bi-monthly :P
sheet I thought it was aftermarket not OEM..30 yrs old & still at school I guess! ;)