Im getting a vtech error on the scanner. Anyone have any ideas on why its saying this
Printable View
Im getting a vtech error on the scanner. Anyone have any ideas on why its saying this
this is a 02 type r by the way
It's VTEC..
Why was a new engine put in? What was it? Need for information..
I suggest you look up the ECU code and go from there.
http://www.ozhonda.com/forum/showthr...K-ECU-for-j00-!
What engine did you put into your DC5?
K20A2, K20Z, K24A3?
The scanner should of told you what you got the CEL for anyways.
my original k20a2 engine blew up so i replaced it with another one. car runs fine but just doesnt have any vtec. im spewingg
You sure you even have a K20A2 ?
You must have a problem.Quote:
Originally Posted by ellie123
ye im pretty sure it is. unless its not a fake badge ? i kno i have a problem thats why i asked. Has anyone come across this
Did you check your CEL? Could be many reasons
it said it was a vtec error but i didnt get the exact code.
YOu need the exact codeQuote:
Originally Posted by ellie123
hahahahah whats a vtec error
who did the swap?
go back to the mechanic who did it
i guess i just gotta get the exact code. spewing harddd hopefully its not a big problem.. do all k20a2 engines usally come with a red rocket cover? if its a k20a3 im gonna go smash the guy a bought the engine off. i guess i gotta see where it redlines at that would tell me
check the engine code on the block next to the starter motor
code does say k20a2
it redlines at 7500 istead of 8 like it used to. no vtec at all and after 5000 rpm car struggles to pull
Low oil pressure? Vtec solenoid might be damaged?
don't drive it like that with a celQuote:
Originally Posted by ellie123
get the exact code and we can start to help out properly
and afaik no australian delivered k20a2's came with a red valve cover, only silver. i think....